Even if I run PSpice-For-TI_setup.exe and enter my email address and access key, a message like the one attached appears and I cannot sign in. What could be the cause?

The I2C operation mode is I2C_OPER_MODE_POLLING, and SENSOR_I2C_TIMEOUT is 5000. When the camera's I2C communication is abnormal, it can sometimes cause the MCU2_0 OS to block for about 18 seconds.

Texas Instruments (TI) Logic support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search logic IC content or ask ...

I have made a custom PCB using MSP430-FR6047 to measure flow. I wanted to know if it was possible to initialise flow parameters (Parameters under configuration tab in USS Design center) directly ...

When I read the values in the Registers Table in BQStudio for my battery assembly I see a voltage value of 7656 mV and individual cell voltage of 3830 mV (Cell 1), 3827 mV (Cell 2) and 3834 mV (Cell 3 ...

I would like to know on the use of TPS6594-Q1 with AM5716AABCXEA. Currently we are using TPS659162RGZR. Is TPS659162RGZR being discontinued? Are there any issues with using the AM5716AABCXEA?

I'm working on an audio recording setup using an Android device with a PCMD3180 PDM-TDM converter that supports 8 DMIC inputs. Despite configuring all 8 channels for recording, only 4 channels are ...

I'm developing support for custom flash device "MX25L12833FM2I-10G". I'm having troubles using the flash in 1S-1S-4S. I managed to configure correctly the flash in the 1S-1S-4S protocol. After ...

Recently, I have updated my board to SDK 10.00.00.08, and I have updated my Docker container accordingly from edgeai-tidl-tools I can compile and run ResNet-18 and MobileNetV2 on my TDA4 board without ...

Now I'm trying to enable the voice-activity-detection function(VAD) on TLV320ADC5120 EVK board, but failed: no interrupt occurs when the signal gets into EVK.

I am making Phase shift full bridge converter by using TMS320F280039C. I am running the voltage controller in CLA as below. Voltage controller execution time is 3us. So running CLA at 300kHz. I want ...

I am using CC2340R5-Q1 and i have merged SPI driver in Basic_BLE code. I am trying to communicate with NTM88 TPMS IC to get the Tire Temperature and Pressure readings. CC2340R5-Q1 is acting as SPI ...