The I2C operation mode is I2C_OPER_MODE_POLLING, and SENSOR_I2C_TIMEOUT is 5000. When the camera's I2C communication is abnormal, it can sometimes cause the MCU2_0 OS to block for about 18 seconds.

Even if I run PSpice-For-TI_setup.exe and enter my email address and access key, a message like the one attached appears and I cannot sign in. What could be the cause?

When I read the values in the Registers Table in BQStudio for my battery assembly I see a voltage value of 7656 mV and individual cell voltage of 3830 mV (Cell 1), 3827 mV (Cell 2) and 3834 mV (Cell 3 ...

I would like to know on the use of TPS6594-Q1 with AM5716AABCXEA. Currently we are using TPS659162RGZR. Is TPS659162RGZR being discontinued? Are there any issues with using the AM5716AABCXEA?

I'm developing support for custom flash device "MX25L12833FM2I-10G". I'm having troubles using the flash in 1S-1S-4S. I managed to configure correctly the flash in the 1S-1S-4S protocol. After ...

Texas Instruments (TI) Logic support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search logic IC content or ask ...

I have made a custom PCB using MSP430-FR6047 to measure flow. I wanted to know if it was possible to initialise flow parameters (Parameters under configuration tab in USS Design center) directly ...

I'm working on an audio recording setup using an Android device with a PCMD3180 PDM-TDM converter that supports 8 DMIC inputs. Despite configuring all 8 channels for recording, only 4 channels are ...

I have designed and prototyped an isolated DC-DC converter using the LM5185QPWPRQ1. The design converts a 24-27V DC input to two isolated 15VDC outputs. Each output is rated for 7.5W, and during our ...

Refer to bsl_software_invoke_app_demo_uart_LP_MSPM0G3507_nortos_ticlang, we want to duplicate the same method to enter BSL mode by invokeBSLAsm() on G3107. But MCU ...

My project using TDA4 VM + SDK 9.1 + EMMC boot. Emmc device type is MTFC32GASAQHD-AAT. EMMC boot is normal without special operations.But emmc boot gets stuck when I do the following operation，These ...

I read that the packet sniffer 2 software contains the firmware that enables CC13xx launchpads to be used as capture device. Source: https://dev.ti.com/tirex/explore ...